A range of new products have been introduced to the market by Aeroflow

Since 2010, Aeroflow Performance Products has grown to design and manufacture close to 13,000 quality products. Amongst the latest releases are the following products.
68mm Bosch Drive by Wire Throttle Body
The Bosch Motorsport drive-by-wire (DBW) electronic throttle bodies are designed to control the fresh air delivery into the engine electronically replacing the mechanical linkage from the accelerator pedal.
This DBW setup will require three things to make it work:

1. An accelerator pedal module (Sold Separately 0 280 755 05),
2. A throttle valve that can be opened and closed by an electric motor (DBW) and
3. A powertrain or engine control module (PCM or ECM) either factory or aftermarket.

The DBW will work with all applications with flex-fuels, CNG and LPG if they are injected in the air stream after the throttle body.
The DBW is great for custom applications when a large throttle body is required with either 68mm, 74mm and 82mm versions available to suit various engine capacities.

Throttle Position Sensor to suit GM
Aeroflow Performance says its GM Original Equipment Throttle Position Sensor (TPS) is the recommended replacement for your GM vehicle’s original component.
The TPS reports the throttle position to the engine control module, which uses the signal to adjust fuel delivery and ignition timing.
The TPS is an equivalent component to AC Delco Part Number 17123852. Plug and pins sold separately (AF49-1520).

Throttle Position Sensor suit Ford
Aeroflow Performance says its Ford Throttle Position Sensor (TPS) is the recommended replacement for your Ford vehicle’s original component.
The TPS reports the throttle position to the engine control module, which uses the signal to adjust fuel delivery and ignition timing.
The TPS is an equivalent component to Ford Motorcraft Part Number E6AZ9B989C.

Universal Bosch Knock Sensor
This Bosch universal knock sensor is used in performance engines to detect knock through your compatible ECU.
This knock sensor can be used in a variety of applications that use a two-pin knock sensor.
Plug and pins sold separately under AF49-1524 Bosch / Jetronic.

Female -3AN to Male -3AN Extension
This extension has a -3AN female on one side and male -3AN flare end on the other end. This makes it great for custom applications that require -3AN fittings to be spaced out for clearance. These -3AN extensions are one-inch (25mm) in length.

For more information, visit www.aeroflowperformance.com